The Arduino-based evaluation kit (EVK) is said to supports the evaluation of ROHM Semiconductor’s motor driver devices and enables, facilitates and accelerates customers’ developments. Designed as a ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

An Arduino Mega 2560 clone is used to control four TB6600 stepper motor drivers, with a common OLED display module installed where the original display went.

He was able to get it running with an Arduino in no time so he decided to take the project a little bit further. What he ended up with is a stepper motor driver which can be controlled over Bluetooth.

TRINAMIC Motion Control's new TMC2660 stepper motor driver IC supports motor drive currents up to 4A. The new IC integrates both a pre-driver for real-time calculation of motor coil current values, ...

Today in devices that use stepper motors to make beautiful music we present to you this Arduino-powered, Raspberry-Pi containing music box that uses ...

Toshiba has launched an 4 x 4mm QFN24 stepper motor driver that can run from 4.5 to 33V and deliver up to 1.2A. Typical on-resistance of the output block is 1.2Ω. “It is well suited for ...

Even first-time users can get a stepper motor moving as commanded in 30 min or less. Commands can be issued from any serial terminal program or from the EZ Stepper Windows program, but the EZHR17EN ...

Recently, I found an interesting fan motor module in a web shop and grabbed a couple of them for nothing. At the heart of the module is an eight-pin L9110 ...